Thermal Dynamics ULTRA-CUT 200 XT, Руководство по эксплуатации

Страница: 49 / 228

ULTRA-CUT 200 XT
Manual 0-5304 INSTALLATION 3-21
NOTE!
There are holes added in the rear panel for customer wiring. This, rather than the one in the CCM will be
the preferred place for customer added wiring (and strain relief) for connections to height controls, etc..
3.15 DMC-3000 Gas Manifold Control Installation
The DMC-3000 Gas Control must be installed in a suitable location where it is easily accessible to the system operator. The unit
must be mounted to a flat horizontal surface. If the Module is mounted to any support subject to vibration or motion, the installer
must fasten the module to the support securely.
The Module should be located as far away as possible from the Arc Starter due to possible electromagnetic interference. It is
acceptable to locate the control cable in the same track as the cables from the Arc Starter and away from torch leads.
The Module includes feet which lift the bottom panel of the mounting surface. Louvers on the back panel of the module must
remain unblocked, for the free passage of ventilating air.
Mounting Dimensions
5.00 in
[127.0 mm]
7.08 in
[179.8 mm]
12.18 in
[309.4 mm]
11.44 in
[290.6 mm]
.30 in
[7.62 mm]
DMC-3000 Top
13.60 in
[345.6 mm]
DMC-3000 Profile
Art # A-09459
Preparation
1. Remove the screws securing the Cover Panel to the Module.
Loosen or remove 2 screws
Remove 2 Screws
Art # A-09139_AC
Cover Removal