Textron PT-3500, Руководство оператора

Страница: 54 / 136

Revolution Series PT-3500 / PT-7500 Puller Tensioner Page 52
Operation
Start-Up Procedure

Perform all pre-operation inspections.

Position the machine and chock wheels. The
machine should be positioned centered on
the lead block, and parallel to the line being
pulled prior to beginning operations. Wheels
should be chocked to prevent the unit from
rolling-
(see Positioning the Machine section).

Ensure that all controls (levers, switches, etc.)
are in the neutral and disengaged position-
(see Operator Controls section).

With the key inserted,
turn master power key
switch
to the On
position-
(see Operator
Controls section).

Once display and panel lights are on, place
Engine Start button to the [START/RUN]
position to start the
engine.
View the control panel screen to ensure that
there are no warning or faults
messages, and that everything is
working properly.


Level and stabilize the machine using the
available hydraulic jacks-
(see Jack Controls
section) .

Properly anchor the machine to prevent the
machine from moving under tension or line
load.
NOTE: Before beginning operations, the operator must perform all pre-operation inspections. (See Pre-Operation
Inspection Checklist on page 103.) Pre-operation inspections are important for the safe operation of the machine,
and are required under OHSA Regulations.
CAUTION: All jacks must be extended for
stabilization, and the machine must be leveled and
anchored prior to conduction operations.
NOTE: The preheat function/glow plugs are
automatically engaged once the Engine Start
Button is placed in the [START/RUN] position. After
the preheat cycle has concluded, about 10 seconds,
the engine will start automatically-
(see Operator
Controls section).
NOTE: Warnings and faults are displayed as a red
icon or button. If warnings or faults are present,
see the faults and diagnostics screens, and check
system
components prior to beginning
operations- (see GENERAL FAULTS section).