Textron PT-3500, Руководство оператора

Страница: 29 / 136

Revolution Series PT-3500 / PT-7500 Puller Tensioner Page 27
Operation
Operator Controls
**For control locations see Operator Control Panel Section on page 20.
System Control Panel
DATA LOGGING
Press and Hold the DATA LOG button to
initiate
system data logging. When the system first
boots up, the default
setting
for data
logging is OFF. The
operator
must
manually initiate
data logging.
FLOAT ARM ON/OFF
When this button is pushed and held it will
toggle the Float Arm
function
of the
levelwind. When the
float arm is On, the
levelwind will float
freely with the line. When the Float Arm is Off
the vertical hydraulic cylinders will hold the
levelwind in position.
RESET TOTAL FEET
When this button is pushed and held for three
seconds, it will reset the footage counter for the
system. The footage counter is displayed at the
top center on the HOME screen.
DEPLOY LEFT/RIGHT JACKS
This button, when pressed,
enables the right and left
jack
controls, while
showing the rear facing camera. This button will
disappear when the joystick is taken out of
neutral, preventing the use of the R/L jacks from
inside the operator cab and disabling interior the
R/L jack controls.
NOTE: The footage counter should only be reset when
the line is all the way out from or onto the drum.
Otherwise, the values will not accurately represent
how much line is on/off the drum.
CAUTION: If using the levelwind during pulling
operations, the Float Arm function should be set to
[ON]. Failure to enable the float arm function could
result in damage to the levelwind as upward line
tension forces might exceed the downward holding
strength of the levelwind and its retainers.
CAUTION: If the levelwind arm is in the upward standby
position and the Float Arm function is enabled, the
levelwind arm will drop rapidly, creating a hazard for
personnel and possible damage to the rope or
levelwind. Use extreme caution if personnel are in the
vicinity as the weight of the falling levelwind could
cause significant injury or death if it strikes a person.
NOTE: When either [RAISE ARM] or [LOWER ARM]
buttons are pressed to actuate the vertical movement
of the levelwind, the [FLOAT ARM] function will
automatically change to the [OFF] position. The
operator will have to re-enable the float arm if it is
needed during pulling operations.