TEXIO DL-1060, Инструкция по эксплуатации

Страница: 126 / 146

120
TRIGger:DELay {< seconds >|MINimum|MAXimum}
Set a trigger delay time in seconds. The delay is the time between the trigger signal and each
sample that follows. Specify a delay time from 0 to 3600 seconds.
TRIGger:DELay?
Query the trigger delay time.
TRIGger:DELay:AUTO {OFF|ON}
Disable or enable a automatic trigger delay. The delay is determined by function, range,
integration time, and ac filter setting. Specifying a delay time automatically turns off the
automatic trigger delay.
TRIGger:DELay:AUTO?
Query the a utomatic trigger delay mode. Returns “0” (OFF) or “1” (ON).
SAMPle:COUNt {< value >|MINimum|MAXimum}
Set the number of readings (samples) the multimeter takes per trigger. Select a number from
1 to 50,000 readings per trigger.
SAMPle:COUNt ? [MINimum|MAXimum]
Query the sample count.
TRIGger:COUNt {< value >|MINimum|MAXimum|INFinite}
Specify the number of triggers the multimeter will accept before returning to the “idle” state.
Select from 1 to 50,000 triggers. The INFinite parameter instructs the multimeter to take
triggers continuously. Trigger count is ignored while in local operation.
TRIGger:COUNt? [MINimum|MAXimum|INFinite]
Query the trigger count. Returns “9.9037” when you select the infinite trigger count.
B.8 The System-Related Commands
FETCh?
Transfer readings stored in memory by the INITiate command to output buffer where you are
able to read them into your bus controller.
READ?
Change the state of the triggering system from the “idle” state to “wait -for- trigger” state. The
meter will start to make measurements when a required triggering condition is met after the
READ? command is received. Measurement readings are sent to the output buffer immediately.
DISPlay {OFF|ON}
Turn off or on the display.