TESVOLT TS Series, Руководство по установке

Страница: 13 / 46

11
www.tesvolt.com
Position
A
Description/Note
Description
AC power cable
Connection AC2 Gen/Grid Terminals L, NTT and PE
Connection to the public mains grid via a 3-core cable
Conductor cross-section: 6 mm² … 16 mm²
B
Protective earthing
conductors
Connection AC1 Loads/SunnyBoys Terminal PE
Additional earth when the conductor cross-section of the AC power cable
is less than 10 mm². The conductor cross-section must be at least the
same as the conductor cross-section of the AC power cable.
Battery connection:
Conductor cross-section: 50 mm² ... 120 mm²
Cable diameter: 14 mm ... 25 mm
Tightening torque: 12 Nm
cabel DC –
cabel DC +
E
C
D
Battery temperature sensor
measuring cable
Connection BatTmp
Only Lead-acid batteries require connection of a battery temperature
sensor. The battery temperature sensor must be mounted in the middle of
the battery array, in the upper third of the battery cell.
F
Sunny Remote Control
data cable Connection Display
G
Speedwire network cable
Connection ComETH
The Speedwire data module (SWDMSI-NR 10) must be installed in the
Sunny Island in order to connect the router/switch (see Installation
instructions for the Speedwire data module SWDMSI-NR 10).
The ComETH connection is located on the data module.
H
Data cable to Lithium-Ion
battery
ComSync In connection
Connection for the Lithium Ion Battery Management System
The communication bus must be connected to the
Lithium-Ion battery and the termination resistor must be
plugged into the ComSync Out connection.
SMA, SUNNY ISLAND and SUNNYPORTAL are registered trademarks of SMA Solar Technology AG in many countries.
E.IA. .ENG- TS A.6