TESVOLT TS Series, Руководство по установке

Страница: 22 / 46

20
www.tesvolt.com
F
G
Battery temperature sensor
measuring cable
Control cable for the
tie-breaker
Sunny Island: Connection Relay1 Terminals C and NC, switching device:
Connection X4 Terminals 1 and 2
The contactor of the coupling switch engages when the multifunction
relay engages. Conductor cross-section: 1.5 mm² ... 2.5 mm²
H
Control cable for contactors
Q4 and Q6
Sunny Island: Connection Relay2 Terminals C and NO
Switching device: Connection X5 Terminals 1 and 2
The contactor engages when the multifunction relay engages.
Conductor cross-section: 1.5 mm² ... 2.5 mm²
I
Measuring cable for
monitoring the tie-breaker
Sunny Island: Connections DigIn+ and Ba
Switching device: Connection X5 Terminals 3 and 4
Use a separate cable as the measuring cable for monitoring the
tie-breaker. This prevents interference in the transmission of signals.
Conductor cross-section: 0.2 mm² ... 2.5 mm²
Connect the DigIn − and BatVtgOut − connections within
the Sunny Island inverter.
Sunny Island: Connection BatTmp
Only Lead-acid batteries require connection of a battery temperature
sensor.The battery temperature sensor must be mounted in the middle
of the battery array, in the upper third of the battery cell.
K
Sunny Remote Control data
cable
Sunny Island: Connection Display
L
Speedwire network cable
Sunny Island: Connection ComETH
The Speedwire data module (SWDMSI-NR 10) must be installed in the
Sunny Island in order to connect the router/switch (see Installation
instructions for the Speedwire data module SWDMSI-NR 10). The ComETH
connection is located on the data module.
M
Battery management data
cable
Sunny Island: ComSync In
Batterie: CAN SMA
SMA, SUNNY ISLAND and SUNNYPORTAL are registered trademarks of SMA Solar Technology AG in many countries
E.IA. .ENG- TS A.6