Terumo BCT T-RAC II, Инструкция по эксплуатации

Страница: 126 / 146

Page 56 of 76
7.2.3 Barcode rules
On screen 6, the way barcodes are compared to each other can be configured. The
checks are done after the reading of each code in a donation cycle. When an error
towards the scheme is detected, an error message will be displayed. T-
RAC II won’t
accept the wrong barcode, another one will need to be scanned. A maximum of 20
equations can be programmed.
Two comparators are available:
• <>
The barcodes at each side of the equation should be different.
• =
The barcodes should be equal.
In each equation, two barcodes can be chosen. Following codes can be chosen:
• Codes present in the program
The available codes are the ones that are present in the program which is currently
being edited.
• BBIS CODE 1 to BBIS CODE 5
These are codes which can be configured through BBIS. These can only be used
when the program is configured for bi-directional communication in TOMEs.
Depending on the version of TOMEs the wording of these codes might differ from
what is shown on T-RAC II:
T-RAC II TOMEs
BBIS CODE 1
BBMS CODE 1 / BBIS IDENTIFIER
BBIS CODE 2
BBMS CODE 2 / BBIS CODE 1
BBIS CODE 3
BBMS CODE 3 / BBIS CODE 2
BBIS CODE 4
BBMS CODE 4 / BBIS CODE 3
BBIS CODE 5
BBMS CODE 5 / BBIS CODE 4
• * (‘all barcodes which are scanned during the donation cycle’)
When using ‘*’ along with the comparator ‘<>’, the code on the other side of the
equation should be different from all other codes read during the donation cycle.
Using this character along with the ‘=’ comparator, is only useful when (a part of)
all barcodes should be equal.
• … (‘empty’)
When at least one of both sides of the equation is ‘…’, the equation is not taken
into account. Use this to delete a barcode comparison.
It is not always required to compare the complete result of the barcodes. Following
parts can be chosen:
• Full
The complete barcodes will be compared.
• Prfx
Only the start flag of the codes (prefix) will be compared.
• Sufx
Only the end flag of the codes (suffix) will be compared.
• Cntr
Only the center part of the codes (without the start and end flag) will be compared.