Telit Wireless Solutions LE910-SKG, Справочник команд AT

Страница: 45 / 273

LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 45 of 273
E - Command Echo
ATE[<n>]
Set command enables/disables the command echo.
Parameter:
<n>
0 - disables command echo
1 - enables command echo (factory default) , hence command sent to the device
are echoed back to the DTE before the response is given.
Note: if parameter is omitted, the command has the same behaviour of
ATE0
Reference V25ter
Q - Quiet Result Codes
ATQ[<n>]
Set command enables or disables the result codes.
Parameter:
<n>
0 - enables result codes (factory default)
1 - disables result codes
2 - disables result codes (only for backward compatibility)
Note: After issuing either
ATQ1 or ATQ2 every information text transmitted in
response to commands is not affected
Note: if parameter is omitted, the command has the same behaviour of
ATQ0
Example After issuing ATQ1 or ATQ2
AT+CGACT=?
+CGACT: (0-1) nothing is appended to the response
Reference V25ter
V - Response Format
ATV[<n>]
Set command determines the contents of the header and trailer transmitted with
result codes and information responses. It also determines if result codes are
transmitted in a numeric form or an alphanumeric form (see [§3.2.3 Information
Responses And Result Codes] for the table of result codes).
Parameter:
<n>
0 - limited headers and trailers and numeric format of result codes
information responses <text><CR><LF>
result codes <numeric code><CR>