Telit Wireless Solutions LE910-SKG, Справочник команд AT

Страница: 262 / 273

LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 262 of 273
#EVMONI – Set the single Event Monitoring
seconds after that the selected GPIO pin in the status specified with
<paramType> = 1 causes the event. The range is 0 – 255.
(Default: 0)
• If
<label> is ADCH1, <paramType> can assume values in the range
0 - 3.
o if <paramType> = 1, <param> indicates the ADC pin number;
supported range is from 1 to a value that depends on the hardware.
(Default: 1)
o if <paramType> = 2, <param> indicates the ADC High voltage
threshold in the range 0 – 2000 mV. (Default: 0)
o if <paramType> = 3, <param> indicates the time interval in
seconds after that the selected ADC pin above the value specified
with
<paramType> = 1 causes the event. The range is 0 – 255.
(Default: 0)
• If
<label> is ADCL1, <paramType> can assume values in the range
0 - 3.
o if <paramType> = 1, <param> indicates the ADC pin number;
supported range is from 1 to a value that depends on the hardware.
(Default: 1)
o if <paramType> = 2, <param> indicates the ADC Low voltage
threshold in the range 0 – 2000 mV. (Default: 0)
o if <paramType> = 3, <param> indicates the time interval in
seconds after that the selected ADC pin under the value specified
with
<paramType> = 1 causes the event. The range is 0 – 255.
(Default: 0)
• If
<label> is SMSIN, <paramType> can assume values in the range
0 - 1.
o if <paramType> = 1, <param> indicates the text that must be
received in incoming SMS to trigger AT command execution rings
after that the event occurs; the maximum number of characters in the
SMS text string is 15
AT#EVMONI?
Read command returns the current settings for each event in the format:
#EVMONI:
<label>,<mode>,<param0>[,<param1>[,<param2>[,<param3>]]]
Where
<param0>,<param1>,<param2> and <param3> are defined as
before for <param> depending on <label> value
AT#EVMONI=? Test command returns values supported as a compound value
#CMGS - Send Message
(PDU Mode)
AT#CMGS=
<length>,<pdu>
(PDU Mode)
Execution command sends to the network a message.
Parameter:
<length> - length of the PDU to be sent in bytes (excluding the SMSC address