Telit Wireless Solutions DE910-DUAL, Справочное руководство

Страница: 179 / 261

DE910-DUAL AT commands reference guide
80392ST10102A Rev.2 – 2012-07-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 179 of 261
#USERID - Authentication User ID
specific value based on carrier’s specification).
Note: this set command is only for authentication information of Simple IP system.
Note: if a wireless service provider supports only Simple IP data network system
such as SK telecom in Korea you need to set this information for data
connection.
Note : if a wireless service provider supports Mobile IP preferred(like Verizon or
Verizon MVNO) or Mobile IP only data network system(like Sprint or
Sprint MVNO) you do not need to set this information because this
information is automatically populated by a device itself based on
carrier’s specification. In case of using Mobile IP system, a specific
profile is used and its information is set by device itself.
Note : although the case of a wireless service provider supporting Mobile IP
preferred dose also support Simple IP(Simple IP fallback due to
authentication fail), a user id for Simple IP does not need to be set(auto
population by device itself)
AT#USERID? Read command reports the current user identification string, in the format:
#USERID: <user>
AT#USERID=? Test command returns the maximum allowed length of the string parameter <user> .
Example AT#USERID="myName"
OK
AT#USERID?
#USERID: "myName"
OK
#PASSW - Authentication Password
AT#PASSW=
[<pwd>]
Set command sets the user password string to be used during the authentication
step.
Parameter:
<pwd> - string type, it is the authentication password; the max length for this value
is the output of Test command, AT#PASSW=? (factory default is the
specific value based on carrier’s specification).
Note: this set command is only for authentication information of Simple IP system.
Note: if a wireless service provider supports only Simple IP data network system
such as SK telecom in Korea you need to set this information for data