Telit Wireless Solutions DE910-DUAL, Справочное руководство

Страница: 140 / 261

DE910-DUAL AT commands reference guide
80392ST10102A Rev.2 – 2012-07-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 140 of 261
#SRS - Select Ringer Sound
AT#SRS=
[<n>,<tout>]
Set command sets the ringer sound.
Parameters:
<n> - ringing tone
0 - current ringing tone
1..
max - ringing tone number, where max can be read by issuing the Test
command AT#SRS=? .
<tout> - ringing tone playing time-out in seconds.
0 - ringer is stopped (if present) and current ringer sound is set.
1..60 - ringer sound playing for
<tout> seconds and, if <n> > 0, ringer sound <n>
is set as default ringer sound.
Note: when the command is issued with
<n> > 0 and <tout> > 0 , the <n> ringing
tone is played for <tout> seconds and stored as default ringing tone.
Note: if command is issued with
<n> > 0 and <tout> = 0 , the playing of the ringing
is stopped (if present) and <n> ringing tone is set as current.
Note: if command is issued with
<n> = 0 and <tout> > 0 then the current ringing
tone is played.
Note: if both
<n> and <tout> are 0 then the default ringing tone is set as current
and ringing is stopped.
Note: If all parameters are omitted then the behaviour of Set command is the same
as Read command
AT#SRS? Read command reports current selected ringing and its status in the form:
#SRS: <n>,<status>
where:
<n> - ringing tone number
1.. max
<status> - ringing status
0 - selected but not playing
1 - currently playing
AT#SRS=? Test command reports the supported values for the parameters <n> and <tout>
#SRP - Select Ringer Path
AT#SRP=[<n>]
It has no effect and is included only for backward compatibility.
Parameter:
<n> : (0-3)