Tektronix RFM220, Руководство пользователя

Страница: 37 / 116

Getting Started
Network Installation
The typical RFM220 system will have the RFM220 Aggregator installed on
a network server where it can communicate with RFM220 instruments on
the network and be accessed by network PCs that have the RFM220 Client
application installed.
In this case, the network server that runs the RFM220 Aggregator must have
two network ports that are dedicated for RFM220 system communications:
Control port. This port connects to the network to which the
RFM220 instruments are connected. You will enter the IP address of the
Control port in the “SNMPCon
fi guration” section of Con fi guration.xml
fi le. (See page 22, Con fi guring the RFM220 Aggregator .)
Corporate port. This port connects to the network to which the PCs
running the RFM220 Client application are connected. You will enter
the IP address of the Corporate port in the “ClientCommunication”
section of Con
fi guration.xml fi le. (See page 22, Con fi guring the
RFM220 Aggregator .)
The RFM220 Aggregator software includes the RFM220 Device Setup
utility that allows users to con
fi gure the network parameters of the RFM220
instrument. Since the RFM220 instrument does not support DHCP service,
you must assign the instrument a speci
fi c IP address. (See page 18,
Con fi guring the Network Settings of a RFM220 Instrument .)
NOTE. If necessary, contact your local network administrator for help in
entering the correct network parameters.
If you lose or cannot remember the IP address of a RFM220 instrument,
you can recover the IP address using an RS-232 command. (See page 77,
Recovering the IP Address .)
Powering the Instrument On and Off
The RFM220 demodulator has a rear-panel power switch located next to the
power cord connector. (See Figure 5 on page 9.)
To power on the instrument, connect the power cord to your local power
source, and then use the rear-panel switch to power on the instrument. The
front-panel Power On LED will light up.
To power off the instrument, use the rear-panel switch to power off the
instrument and then remove the power cord from the power source.
RFM220 User Manual 11