Getting Started
Connecting Signals to
the Instrument
The external connectors are all located on the rear panel of the instrument.
(See Figure 43.) Refer to the
RFM220 Speci
fi
cations and Performance
Veri
fi
cation Technical Reference
for more detailed information about each
connector and the associated signal requirements.
NOTE.
The 1PPS In connector is not used. Do not connect a signal cable
to this connector.
Figure 5: RFM220 rear panel
After you install the RFM220 demodulator in the desired location, connect
the power cord that was provided with the instrument to the power connector
on the rear panel. Connect the power cord plug to a properly grounded
electrical outlet.
CAUTION.
To be sure of compliance with speci
fi
ed EMC standards and
directives, use only high quality shielded cables with this product. Equipment
performance can be affected. Typically, the cables are braid and foil types that
have a low impedance connection to shielded connectors at both ends.
RFM220 User Manual
9
Содержание RFM220
