Tektronix RFM220, Руководство пользователя

Страница: 44 / 116

Getting Started
12. After the software is installed, shortcut icons will appear on your desktop
for the RFM220 Aggregator and/or RFM220 Client applications you
installed. The RFM220 Aggregator, RFM220 Client, and RFM220 Device
Setup applications are also listed in the Start menu under All Programs
> Tektronix.
You can copy the RFM220 Device Setup shortcut from the Start menu to
your desktop. The shortcut icons for all three RFM220 applications are
shown below.
Figure 11: RFM220 shortcut icons
Con fi guration
Con fi guring the
Network Settings of
a RFM220 Instrument
In order for the Aggregator to monitor a RFM220 instrument, the instrument
must be on the same network as the computer hosting the Aggregator. In order
for the RFM220 Client to communicate with an Aggregator, the Aggregator
and Client computers must be on the same network. The RFM220 instrument
and the Client computers should also be connected to the same network
subnet, if present.
The RFM220 Aggregator software includes the RFM220 Device Setup utility
that allows you to con
fi gure the network parameters of a RFM220 instrument.
Since the RFM220 instrument does not support DHCP service, you must
assign the instrument a speci
fi c IP address.
NOTE.
If necessary, contact your local network administrator for help in
entering the correct IP address parameters.
If you lose or cannot remember the existing IP address of a RFM220 instrument,
you can recover the IP address using an RS-232 command. (See page 77,
Recovering the IP Address.)
18 RFM220 User Manual