Getting Started
11.
If you will be using an Network Management System (NMS) to monitor
SNMP traps sent by the RFM220 system, perform the following steps.
Otherwise, leave these
fi
elds blank and go to step 12.
a.
Enter the IP address of the PC or server hosting the NMS system in
the New secondary trap box.
b.
Enter the port number that will receive SNMP traps on the PC or
server hosting the NMS system in the New port number box.
c.
Click
Save new second trap settings
.
CAUTION.
If you enter a secondary trap destination, you need to ensure
that the secondary trap port number is added to the Windows Firewall
exceptions on the PC or server hosting the NMS system. This enables the
NMS system to receive traps from the RFM220 system.
If you click Save new second trap settings, you must enter a valid IP
address and port number for the secondary trap destination. You will
receive an error message if a valid IP address is not entered.
12.
Remove power from the instrument, connect the instrument to your
network, and then reapply power.
13.
On a PC that is connected to the same network as the instrument and
has the RFM220 Aggregator software installed, use the RFM220 Device
Setup utility to connect to the instrument using the new IP address.
14.
In the RFM220 Device Setup dialog:
a.
Click
Reset to default settings
.
b.
Click
Reset device
.
15.
Close the RFM220 Device Setup dialog.
RFM220 User Manual
21
Содержание RFM220
