Tecnoalarm TP8-64 BUS, Руководство по установке

Страница: 129 / 246

TP8-64 BUS - Installer Manual Programming by PC
4-35
z
Remote activation
Activation of the associated remote control (1 to 8).
z
Remote deactivation
Deactivation of the associated program (1 to 8).
To associate a function to one of the function keys select the
item next to the number of the function key and scroll down
the list, then select from the device to be activated or
deactivated by clicking on the item and scrolling down the list.
PPROGRAMMING OF THE ATTRIBUTES
To associate the attributes to the key check the relevant item.
z
By-pass
Changes the meaning of arming and disarming of the
associated programs:
• Arming program
becomes Start by-pass of program
• Disarming program becomes End of by-pass of program
• Disarming
becomes End of by-pass
z
By-pass of general alarms
Enables the user for arming of the system even in
presence of a general alarm (i.e. tamper, low battery,
power failure, supervision, trouble modules).
z
Automatic communicator block on disarming
If enabled, upon disarming of the system (pressing the
corresponding function key) the active telephone channels
(and those queued up) are blocked automatically.
z
Confirmation of disarming (hold-up block)
Activates the hold-up function on the wireless key. In this
case, disarming by this wireless key will have to be
confirmed by entering of a valid user code within a
determined period of time (disarming confirmation delay),
otherwise a silent hold-up alarm will be released.
z
Hold-up
If enabled, it is possible to release a hold-up (panic) alarm
and activate the relative output by simultaneously pressing
the keys 2 and 3 of the wireless key.
z
Exclusion disabled
Disables the user for arming of the control panel excluding
some of the zones (both voluntary and automatic zone
exclusion are disabled). The control panel will be armed in
any case, and if there are open zones, the alarm will be
released.
z
Siren impulse on arming
If enabled, on arming of the control panel, the siren is
activated for a few seconds (1 impulse).
Repeat the procedure for all the wireless keys (1 to 32).
Once you have finished programming of the wireless keys,
press:
z
OK to confirm and quit
z
Abandon to quit without saving