Tecnoalarm TP8-64 BUS, Руководство по установке

Страница: 190 / 246

Control by console Installer Manual - TP8-64 BUS
6-14
6.7 RESET OF LED SIGNALING
Once the alarm has been stopped, the alarm LED become lit indicating that the alarm
has been recognized and the alarm calls programmed have been executed, and that
the alarm has been stored in the event buffer. Alarm memory signaling persists when
the control panel is put into stand-by.
On the other hand, blinking LED indicate the presence of active alarms, or active
alarm call cycles or that the alarm call cycles have been finished but the alarm
persists, e.g. low battery or power failure.
Alarm memory signaling in stand-by (LED lit) can be reset by the holder of the master
code even if it does not affect functioning of the control panel.
6.7.1 RESET OF LED SIGNALING WITH MASTER CODE
Enter the master code (default code 12345), followed by the MEM and the EXIT keys,
e.g:
+
12345
MEM EXIT
All the LED previously lit are switched off. The alarms remain however stored in the
event buffer of the control panel.
6.7.2 RESET OF LED SIGNALING WITH INSTALLER CODE
(TAMPER LED SIGNALING)
Enter the installer code (default code 54321), followed by the MEM and the EXIT
keys, e.g:
+
54321
MEM EXIT
All the LED previously lit are switched off. The alarms remain however stored in the
event buffer of the control panel.
WARNING
Even if alarm memory signaling has no effect on functioning of the control panel and can therefore
remain lit, it is recommended to reset it for reasons of confusion once the reason of alarm has been
identified.
LED signaling can be reset by the holder of the master code only.
WARNING
The active alarms are not stopped upon reset of alarm memory signaling.
LED signaling for tamper and general alarm (e.g. low battery, power failure) cannot be reset by the
user. Consult the installer.
- ACCESS -
Master
Viewing
Events
- ACCESS -
Installer
Viewing
Events
Tue 19 JUN 07
Work. 10 : 45
Tue 19 JUN 07
Work. 10 : 45