Tecnoalarm TP8-64 BUS, Руководство по установке

Страница: 160 / 246

Programming by console Installer Manual - TP8-64 BUS
5-22
Setting 6
Vocal block [ ]
• Block all the channels
On reception of the blocking command, the control panel
checks if there are events queued up. If there are not or a
single type protocol has been programmed, it closes the
communication and blocks the phone call cycles of all the
vocal and digital channels associated to the event.
[ ] Block the single channel
[ # ] Block all the channels
z
Vocal block Interruption of all the vocal calls by pressing the star key (*) on
the telephone dial during a vocal communication. On reception
of the blocking command, the control panel can:
•
Block the single channel
On reception of the blocking command, the control panel
closes the communication and blocks the active phone call
cycle of this channel.
• Block all the channels
On reception of the blocking command, the control panel
closed the communication and blocks the phone call cycles
of all the vocal channels associated to the event.
[ ] Block the single channel
[ # ] Block all the channels
z
Digit. block Interruption of all the active digital calls using non Tecnoalarm
protocols. On reception of the blocking command, the control
panel can:
•
Block the single channel
On reception of the blocking command, the control panel
checks if there are events queued up. If there are not or a
single type protocol has been programmed, it closes the
communication and blocks the active phone call cycle of
this channel. In all the other cases, the next event is
transmitted.
• Block all the channels
On reception of the blocking command, the control panel
checks if there are events queued up. If there are not or a
single type protocol has been programmed, it closes the
communication and blocks the phone call cycles of all the
digital channels using non-Tecnoalarm protocols
associated to the event.
[ ] Block the single channel
[ # ] Block all the channels
z
Tecno block Interruption of all the active digital calls using the Tecnoalarm
protocol. On reception of the blocking command, the control
panel can:
•
Block the single channel
On reception of the blocking command, the control panel
checks if there are events queued up. If there are not or a
single type protocol has been programmed, it closes the
communication and blocks the active phone call cycle of
this channel. In all the other cases, the next event is
transmitted.
• Block all the channels
On reception of the blocking command, the control panel
checks if there are events queued up. If there are not or a
single type protocol has been programmed, it closes the
communication and blocks the phone call cycles of all the
digital channels using theTecnoalarm protocol associated
to the event.
[ ] Block the single channel
[ # ] Block all the channels
z
Opening msg Enables the vocal opening message anticipating every voice
message transmitted.
z
Ring back Permits enabling/disabling of the ring back check prior to
transmitting voice messages.
z
Rings Defines after how many rings the control panel is to answer to
incoming calls (from 3 to 17).
Setting 7
Digit. block [ ]
Setting 8
Tecno block [ ]
Setting 9
Opening msg [ ]
Setting 10
Ring back [ ]
Setting 11
Rings [ ]