Tandberg Data
Chapter 6 - Trobleshooting
Error Codes
The error codes are listed in numerical sequence by their
Fault Symptom Code (FSC)
in the tables that follow. If a persistent error condition prompts you to call your
Technical Support representative, be sure to furnish the code information to help
identify the problem.
System Error Codes
FSC
Display Message
Description
Source of Failure
Suggested Action
0101 Unused Interrupt
An unused interrupt
was detected.
0102 Enqueue'g a Null Ptr
NULL pointer detected
in message queue.
Robotics Assembly
Press the REBOOT
button on the Control
Panel.
Trace Error Codes
FSC
Display Message
Description
Source of Failure
Suggested Action
0201 Trc COMM Open Error Unable to open Trace
com port.
0202 Drv COMM Open
Error
Unable to open Drive
com port.
Robotics Assembly
Press the REBOOT
button on the Control
Panel.
Novram Error Codes
FSC
Display Message
Description
Source of Failure
Suggested Action
0301
Novram Init. Error
Could not initialize the
configuration area of
the flash device.
0302
Novram CHKSUM
Error
Checksum error
detected in the
configuration area of
the flash device.
0303
Novram Update Error
Could not update the
configuration area of
the flash device.
Robotics Assembly
Press the REBOOT
button on the Control
Panel.
Press the Exit button and
continue.
Press the REBOOT
button on the Control
Panel.
Printf Error Codes
FSC
Display Message
Description
Source of Failure
Suggested Action
0401
Invalid Display Line
Attempting to write to
a non-existent display
line (Firmware Error).
Robotics Assembly
Contact Tandberg Data
for new firmware.
Flash with new firm-ware.
See
Installing Firmware
Upgrades
in Chapter 4.
58
Tandberg SLR Autoloader Service and Repair Manual