Magazine Handling
You must remove the magazine from the unit in order to insert or remove cartridges.
When inserting cartridges, be sure that the slot you intend to use is not already
reserved in the system map for a cartridge in a drive. The best way to avoid conflicts
is to unload the drive, either through your host computer software or by using the
Unload
button on the control panel.
Note
: You cannot insert or remove the magazine if the unit is password protected or
locked by host software.
Inserting a Magazine into the Unit
If the magazine door on the front of the module is closed and locked, open it, as
follows:
1. Press the
Open Door
button.
The magazine door swings open.
2. Slide the magazine through the door opening, with the cartridges protruding
from the front and the molded top arrow facing up.
3. When the magazine is fully inserted, push the door closed until it locks. The
door will not close if the magazine is not fully inserted.
Removing the Magazine
Whenever the front panel door is closed, it is locked in place to prevent tampering or
accidental removal. To remove the magazine, press the
Open Door
button on the
control panel. After a short delay, the shuttle moves to the Door Latch Release to
activate the door latch, which opens the front panel door.
Tandberg SLR Autoloader Service and Repair Manual
40