136
TimeProvider 2300/2700 User’s Guide
098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
To provision the delay limit, the minimum interval (maximum rate) between PTP
delay response messages, for the Master with the Telecom-2008 (unicast) active
profile:
set ptp master config eth2 telecom-2008 delay-limit
<delay-limit-value>
– The interval is 2
z
seconds, where z= <delay-limit-value>.
PTP MASTER - ITU-G.8265-1 Profile Attributes:
To provision the active profile for PTP master:
set ptp master active-profile eth2 itu-g8265-1
To provision the state of the Two-Step Clock mode, for the Master with the
ITU-G.8265-1 (unicast) active profile:
set ptp master config eth2 itu-g8265-1 two-step {enable |
disable}
– If the Two-Step Clock state is Disable, a One-Step Clock is used.
To provision the timescale to Automatic, Arbitrary or PTP for the Master with the
ITU-G.8265-1 (unicast) active profile:
set ptp master config eth2 itu-g8265-1 timescale {auto| arb
| ptp}
– If the timescale is set to “auto”, the TP 2300/2700 will make the decision
based on the input. The TP 2300/2700 will set the timescale to “ptp” if the
unit is locked to gnss or ptp. The TP 2300/2700 will set the timescale to
“arb” if the unit is locked to any other reference besides gnss or ptp (i.e.,
E1, T1 or SyncE).
To provision the state for the Master with the ITU-G.8265-1 (unicast) active
profile:
set ptp master config eth2 itu-g8265-1 ptp-state {enable |
disable}
To provision the PTP priority1 value for the Master with the ITU-G.8265-1
(unicast) active profile:
set ptp master config eth2 itu-g8265-1 priority-1
<priority-1-value>
To provision the PTP priority-2 value for the Master with the ITU-G.8265-1
(unicast) active profile:
set ptp master config eth2 itu-g8265-1 priority-2
<priority-2-value>
