A-96.250.511 / 091120
AMI Turbiwell
Program List and Explanations
100
5.3.2.6
Signal Outputs
: Select operating mode of the signal output:
5.3.2.7
Output/Control
: Select operating mode of the controller output:
The relay contact can be activated daily, at any time of a day.
5.3.2.341
Start time
: to set the start time proceed as follows:
1
Press [Enter], to set the hours.
2
Set the hour with the [
] or [
] keys.
3
Press [Enter], to set the minutes.
4
Set the minutes with the [
] or [
] keys.
5
Press [Enter], to set the seconds.
6
Set the seconds with the [
] or [
] keys.
Range: 00:00:00–23:59:59
5.3.2.44
Run Time
: see Interval
5.3.2.54
Delay
: see Interval
5.3.2.6
Signal Outputs
: see Interval
5.3.2.7
Output/Control
: see Interval
The relay contact can be activated at one or several days, of a week.
The daily starting time is valid for all days.
5.3.2.342
Calendar
:
5.3.2.342.1
Start time
: The programmed start time is valid for each of the pro
-
grammed days. To set the start time see
Range: 00:00:00–23:59:59
Cont.:
Signal outputs continue to issue the measured value.
Hold:
Signal outputs hold the last valid measured value.
Measurement is interrupted. Errors, except fatal errors,
are not issued.
Off:
Signal outputs are switched off (set to 0 or 4 mA).
Errors, except fatal errors, are not issued.
Cont.:
Controller continues normally.
Hold:
Controller continues based on the last valid value.
Off:
Controller is switched off.
5.3.2.24
daily
5.3.2.24
weekly
Содержание AMI Turbiwell
Страница 1: ...Operator s Manual Firmware V6 23 and higher AMI Turbiwell A 96 250 511 091120 ...
Страница 35: ...A 96 250 511 091120 AMI Turbiwell Installation 35 Degasser G B C Degasser sample inlet Drain Waste B G C ...
Страница 108: ...A 96 250 511 091120 AMI Turbiwell Notes 108 12 Notes ...
Страница 109: ...A 96 250 511 091120 AMI Turbiwell Notes 109 ...
