Suzuki VZR1800 2007, Руководство по обслуживанию

Страница: 156 / 609

ENGINE 3-99
• Position the gaps of the three ring as shown. Before inserting
each piston into the cylinder, check that the gaps are so
located.
C
2nd ring and lower side rail
D
Upper side rail
E
1st ring and spacer
• Apply a small quantity of MOLYBDENUM OIL SOLUTION
onto each piston pins, front and rear.
(
MOLYBDENUM OIL SOLUTION
• Assemble the pistons and conrods, front and rear.
NOTE:
When installing the pistons, front and rear, the indents
A
on the
piston heads must be located to each exhaust side.
• Place a clean rag over the cylinder base so as not to drop the
piston pin circlips into the crankcase.
• Install the piston pin circlips, front and rear.
"
NOTE:
End gap of the circlip should not be aligned with the cutaway in
the piston pin bore.
EX
IN
120 ¡
120 ¡ 120 ¡
Front
Rear
Use new piston pin circlips to prevent circlip failure
which will occur with a ben
t
one.
Front
Rear