Sur-Gard SG-System III, Руководство по эксплуатации

Страница: 97 / 131

CHAPTER SIX - SG-DRL3-IP PROGRAMMING
94
SG-Sys
tem I Operating Man
ual
6
Option 2B: Busy Out
Default (00)
The line card will stop acknowledging transmitter events under specific trouble conditions if Option 27 is programmed with the following:
NOTE: If this 01 is selected, the line card will overwrite the oldest alarm with a new alarm when the internal buffer is full.

For UL Listed products, the permitted setting is 00.
Option 2C: Internal Messages RS-232
Default (01)
When this option is programmed as “00”, the SG-DRL3-IP will output its internal messages in the following format:
If it is programmed as “01” internal messages will be output as:
Options 3A-3B Console Port
Defaults (0B), (F8) This represents 3064
These options set the 2 byte Console Connection Port Number with high byte in section 3A and low byte in section 3B. If this option is
changed, the console connected to the SG-DRL3-IP must be programmed with the new port number.
00 No time set from SG-CPM3, a code corruption checksum error, or an
internal buffer is in full condition
01 Line card is being downloaded
04 No time set from SG-CPM3, a code corruption checksum error, line
card is being downloaded, if internal buffer is full, or loss of communi-
cation with the SG-CPM3
05 No time set from the SG-CPM3, automation computer is absent, loss of
SG-CPM3, line card is being downloaded
SRRLLL[#AAAA|Nxxyy]
0RRLLL[#AAAA|Nxxyy]
S, 0 (zero) = Protocol number
RR = Receiver number
LLL = Line number
AAAA = Account code, always 0000
00 = Output for all internal signals is SRRL protocol
01 = Output for all internal signals is 0RRL protocol
02 = Output signals in automation protocol SRRL with leading
space in the zone (DVACS only)
03 = Output signals in automation protocol 0RRL with leading
space in the zone (DVACS only)