Sur-Gard SG-System III, Руководство по эксплуатации

Страница: 47 / 131

CHAPTER FIVE - ADVANCED PROGRAMMING
44
SG-Sys
tem I Operating Man
ual
5
Profiles Introduction
The DRL3/DRL3E/DRL3-2L 'virtual receiver' will load unique 'profiles' in order to effectively communicate with control panels. A profile
is a set of pre-programmed line card options unique for a particular DNIS number. The 'DNIS' will point to a particular profile, which will
then be loaded into the line card before the first handshake is sent. It is essential that the correct option be programmed for a profile in order
to correctly communicate with the control panel. Each 'virtual receiver' can have a maximum of 64 profiles. To change the options for a par-
ticular profile, the SG-Systems Console software is provided. This software will allow the user/operator to edit the profiles.
NOTE: DNIS (Dialled Number Identification Service): This number represents the dialled number, or the num-
ber being called. ANI (Automatic Number Identification): This number represents the source of a call and
allows the system to determine the handshake protocol. Caller ID: This number identifies the source of a call.
For the purpose of this document, Caller ID and ANI will be referred to as Caller ID, but both can not be used at
the same time. Contact your provider to determine which service is available. DNIS cannot be used with Caller
ID, only ANI.
DNIS or Caller ID can be used for profile selection.
Line Cards Identification Number Handling:
Figure 5-1, Call Processing Flowchart
Receive DNIS
or Caller ID
Send string to
Lookup Table
Use Profile 0
Point to Profile #
Done
Use options
from profile
Corresponding
Profile?
Correct amount
of DNIS digits?
Hang up and generate
Communication fail
NO
YES
NO
YES