Sur-Gard SG-System III, Руководство по эксплуатации

Страница: 67 / 131

CHAPTER FIVE - ADVANCED PROGRAMMING
64
SG-Sys
tem I Operating Man
ual
5
Setting this option does not affect the output of pulse signals converted to SIA that did not start with a HEX digit.
Bit 7 – Brinks Recovery
When enabled the line card will not check for an ITI carrier on a full duplex SIA (FC) handshake
SG-DRL3 Option 73: Input/Output Sensitivity

SG-DRL3-2L/DRL3E Option 173/273: Input/Output Sensitivity
Default (15)
This option serves the dual purpose of setting the DSP input sensitivity and the DSP output level. The first digit will set the input sensitivity
of the DSP and the second digit will set the output level of the handshake/kiss off. Refer to the chart below for ranges. For the first digit, 0 is
the most sensitive and 5 is the least sensitive. For the second digit, B is the loudest and 9 is the quietest.
NOTE: For more information, please contact Sur-Gard Technical Support.
SG-DRL3 Option 74: Equivalent Line Number

SG-DRL3-2L Option 174/274: Equivalent Line Number
Default (00)
The equivalent line number is used with the receiver number for sending signals to the central station software. This option may be used if
there is no DNIS number being received by the line card.
First Digit Set To Input Sensitivity Second Digit Set To DSP Output
0x Most Sensitive xB Loudest
1x Default xC
3x Less Sensitive xD
5x Least Sensitive xE
xF
x0
x1
x2
x3 DRL3 default
x4
x5 DRL3-2L/DRL3E
default
x6
x7
x8
x9 Quietest