Supermicro SSE-G2252, Руководство пользователя

Страница: 214 / 1401

Chapter 9: Congestion Control
Automatic Traffic Control
– 218 –
CLI R
EFERENCES
•
“auto-traffic-control apply-timer” on page 788
•
“auto-traffic-control release-timer” on page 788
C
OMMAND
U
SAGE
•
After the apply timer expires, the settings in the Traffic > Automatic
Traffic Control (Configure Interface) page are used to determine if a
control action will be triggered (as configured under the Action field) or
a trap message sent (as configured under the Trap Storm Fire field).
•
The release timer only applies to a Rate Control response set in the
Action field of the ATC (Interface Configuration) page. When a port has
been shut down by a control response, it must be manually re-enabled
using the Manual Control Release (see page 219 ).
P
ARAMETERS
These parameters are displayed:
•
Broadcast Apply Timer – The interval after the upper threshold has
been exceeded at which to apply the control response to broadcast
storms. (Range: 1-300 seconds; Default: 300 seconds)
•
Broadcast Release Timer – The time at which to release the control
response after ingress traffic has fallen beneath the lower threshold for
broadcast storms. (Range: 1-900 seconds; Default: 900 seconds)
•
Multicast Apply Timer – The interval after the upper threshold has
been exceeded at which to apply the control response to multicast
storms. (Range: 1-300 seconds; Default: 300 seconds)
•
Multicast Release Timer – The time at which to release the control
response after ingress traffic has fallen beneath the lower threshold for
multicast storms. (Range: 1-900 seconds; Default: 900 seconds)
W
EB
I
NTERFACE
To configure the response timers for automatic storm control:
1.
Click Traffic, Auto Traffic Control.
2.
Select Configure Global from the Step field.
3.
Set the apply and release timers for broadcast and multicast storms.
4.
Click Apply.