Supermicro SSE-G2252, Руководство пользователя

Страница: 134 / 1401

Chapter 5: Interface Configuration
Trunk Configuration
– 137 –
W
EB
I
NTERFACE
To display LACP settings and status for the remote side:
1.
Click Interface, Trunk, Dynamic.
2.
Select Configure Aggregation Port from the Step list.
3.
Select Show Information from the Action list.
4.
Click Internal.
5.
Select a group member from the Port list.
Figure 5-35: Displaying LACP Port Remote Information
C
ONFIGURING
L
OAD
B
ALANCING
Use the Interface > Trunk > Load Balance page to set the load-distribution
method used among ports in aggregated links.
CLI R
EFERENCES
•
C
OMMAND
U
SAGE
•
This command applies to all static and dynamic trunks on the switch.
•
To ensure that the switch traffic load is distributed evenly across all
links in a trunk, select the source and destination addresses used in the
load-balance calculation to provide the best result for trunk
connections:
•
Destination IP Address : All traffic with the same destination IP
address is output on the same link in a trunk. This mode works best
for switch-to-router trunk links where traffic through the switch is