Supermicro SSE-G2252, Руководство пользователя

Страница: 1296 / 1401

Chapter 42: OAM Commands
– 1310 –
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Interface Configuration
C
OMMAND
U
SAGE
•
If the remote device also supports OAM, both exchange Information
OAMPDUs to establish an OAM link.
•
Not all CPEs support OAM functions, and OAM is therefore disabled by
default. If the CPE attached to a port supports OAM, then this
functionality must first be enabled by the efm oam command to gain
access to other remote configuration functions.
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#efm oam
Console(config-if)#
efm oam
critical-link-event
This command enables reporting of critical event or dying gasp. Use the no
form to disable this function.
S
YNTAX
[ no ] efm oam critical-link-event { critical-event | dying-gasp }
critical-event - If a critical event occurs, the local OAM entity (this
switch) indicates this to its peer by setting the appropriate flag in
the next OAMPDU to be sent and stores this information in its OAM
event log.
dying-gasp - If an unrecoverable condition occurs, the local OAM
entity indicates this by immediately sending a trap message.
D
EFAULT
S
ETTING
Enabled
C
OMMAND
M
ODE
Interface Configuration
C
OMMAND
U
SAGE
•
Critical events are vendor-specific and may include various failures,
such as abnormal voltage fluctuations, out-of-range temperature
detected, fan failure, CRC error in flash memory, insufficient memory,
or other hardware faults.
•
Dying gasp events are caused by an unrecoverable failure, such as a
power failure or device reset.