Sundance Spas Claremont 980 Series, Руководство пользователя

Страница: 64 / 88

Page 58
980™ Series
Procedure:
1. Grasp center filter insert end cap (2) in hand and pull outward from
pleated cartridge (1). If filter insert (2) is 6 months old, throw it away
and purchase new one. DO NOT install new insert at this time.
2. Rinse debris from all outer filter
(1) pleats using a garden hose
and high-pressure nozzle. Repeat
process until all filter pleats are
clean. Then rinse debris from
inside of filter (1). If chemical
cleaners are used, follow
manufacturers instructions.
Lightly rise filter insert (2) and
place in clean location. *DO
NOT use chemical cleaners or high-pressure nozzle on insert (2) or
it may be damaged, come apart or allow impurities to re-enter the
water, increasing the risk of contracting a waterborne illness (e.g. an
infection bacteria or virus) and/or respiratory ailments.
3. Install filter insert (2) into outer pleated filter (1) by gently sliding
inward until a slight resistance is felt approximately 1/4" from bottom.
Lightly tap insert end with palm of hand to “snap” in place. Insert is
properly installed when end cap rests “flush” against outer filter end
cap.
4. Install Filter assembly back into spa by performing step 2 in reverse
order. Tighten filter nut so it just touches the filter face. DO NOT
OVERTIGHTEN!
5. Turn power to spa back on.
Replacement filter cartridges may be purchased from your Sundance
Spas dealer.
13.2 Removing the cabinet panels
The quick removal of the cabinet panels
provide easy access to the equipment bay and
components without having to unscrew the
panel. To remove the panels follow the steps
below:
1. Grab one of the corner panels, from
the bottom, and gently pull the cabinet
forward to unsnap it from the holding clip.
Then slide it down to remove. Place the panel in a safe
location to prevent from damaging it. Repeat the steps to
remove the other corner panel, Figure 13.2a.
1
2
Top
1
2*
Power on Lamp on
DANGER! TURN POWER
OFF! DO NOT LOOK AT LIT BULB. SEVERE EYE
DAMAGE OR BLINDNESS CAN OCCUR!
Figure 13.2a
Figure 13.2b
Power on Lamp on
DANGER!
TURN POWER OFF! DO NOT
LOOK AT LIT BULB. SEVERE EYE
DAMAGE OR BLINDNESS CAN OCCUR!