Sundance Spas Claremont 980 Series, Руководство пользователя

Страница: 18 / 88

Page 12
980™ Series
5.0 General Electrical Safety Instructions
Your new Sundance Spas hot tub is equipped with the “state-of-
the-art” equipment system. It contains the most advanced safety
and self-protective equipment in the industry. Nonetheless, this
hot tub must be installed properly to ensure dependable usage. Please
contact your local Sundance Spas dealer or local building department
should you have any questions regarding your installation.
Proper grounding is extremely important. Sundance hot tubs are
equipped with a current collector system. A pressure wire connector is
provided on the surface of the control box, located inside the equipment
door (Figure C, page 15) to permit connection of a bonding wire
between this point and any ground metal equipment, metal water pipe or
conduit within 5 feet (1.5m) of the hot tub, or copper clad grounding rod
buried within 5 feet (1.5m) of the hot tub. Bonding wire must be at least
No. 8 AWG (8.4 mm²) solid copper wire. This is a most important safety
assurance feature.
Before installing your hot tub, check with your local government/electrical
authority to ensure installation conforms to local country/area state
codes.
6.0 Electrical Installation Instructions (240V Service)
IMPORTANT NOTICE: The electrical wiring of this hot tub must
meet the requirements of the National Electrical Code (NEC) and
any applicable state, local or country codes. The electrical circuit
must be installed by a qualified electrician and approved by a local
building/electrical inspection authority in your state or country.
1.
!
DANGER:
TO DECREASE THE RISK OF SHOCK,
PRODUCT DAMAGE OR ELECTRICAL FIRE.
This hot tub must be permanently connected (hard-wired) to the
power supply. No plug-in connections or extension cords are
to be used in conjunction with the operation of this hot tub.
Supplying power to the hot tub which is not in accordance with these
instructions will void both the independent testing agency listing and
the manufacturer’s warranty.
2. The power supplied to this hot tub must be a dedicated circuit with no
other appliances or lights sharing the power provided by the circuit.
3. To determine the current, voltage and wire size required, refer to
Section 7.0 (page 16) for your specific hot tub model.
• Wire size must be appropriate per NEC and/or local/country codes.
• We recommend type THHN wire.
• All wiring must be copper to ensure proper connections. Do not use
aluminum wire.