Chapter 2
Server Module Installation and Power-On
19
6. Slide the new HDD into the vacant HDD slot by pressing on the middle of the
HDD faceplate with your thumb or finger.
7. Ensure that the HDD ejector lever is two-thirds open (approximately 60 degrees
with respect to the faceplate) when sliding in the HDD into the slot.
Do not slide the HDD in all the way. Leave the HDD out approximately 0.25 to
0.50 inch from the opening.
8. Using your thumb or finger, press on the middle of the HDD front faceplate
until the ejector lever engages with the server module.
Pivot the ejector lever until it clicks into place and the lever becomes flush with
the HDD faceplate.
9. To install a second hard disk drive, repeat Steps 1 through 8.
