Sun Microsystems Blade X6450, Руководство по обслуживанию

Страница: 78 / 162

3-4 Sun Blade X6450 Server Module Service Manual • May 2009
TABLE 3-1
Front Panel LED Functions
LED Name Description
Locate button/LED–White This LED helps you to identify which system you are
working on.
The following actions activate it:
Push and release this button , or use service processor
commands to make the Locate LED blink for 30 minutes.
• From the ILOM web interface:
1) Navigate to System Monitoring -> Indicators.
2) Highlight Sys/Locate.
3) select Turn LED Off or Set LED to Fast Blink from the pull
down menu.
• From the ILOM CLI, enter:
/SYS/LOCATE value=FastBlink
or
/SYS/LOCATE value=Off
Hold down this button for 5 seconds to initiate a “lamp
test”
mode that illuminates other LEDs for 15 seconds.
Ready to Remove LED–Blue The server module is ready to be removed from the chassis.
• For ELOM or ILOM 2.0, this LED is switched on by the
service processor when the server module main power is
off.
• For ILOM 3.0, this LED can only be switched on and off
by using the ILOM web interface or CLI.
Service Action Required
LED–Amber On systems equipped with an ELOM service processor, this
LED has three states:
• Off: Normal operation.
• Slow Blinking: A new (unacknowledged) event requiring
a service action has been detected.
• On: The event has been acknowledged, but the problem
still requires attention.
On systems equipped with an ILOM service processor, this
LED has two states:
• Off: Normal operation.
• On: Fault detected.
Power/OK LED–Green Off – Server main power and standby power are off.
Standby Blinking (.1 sec On, 2.9 sec Off) – Standby power.
On – Server is in main power mode.
ELOM and ILOM 2.0 Startup The blue, amber, and green LEDs blink at 1 second intervals
until the ILOM services are running.