Sun Microsystems Blade X6450, Руководство по обслуживанию

Страница: 32 / 162

2-2 Sun Blade X6450 Server Module Service Manual • May 2009
2.1 Powering On the Server Module
This section contains procedures for powering on the server module.
Note –
Before powering on your server for the first time, follow the installation
instructions provided in the Sun Blade X6450 Modular Server Installation Guide ,
(820-1182.)
Caution –
Severe damage to server components can occur if the server is operated
without adequate cooling mechanisms. Do not operate the server without all
component heatsinks, air baffles, and covers installed.
▼
To Power On the Server Module
1. When you insert your server module into a chassis that is powered on, it comes
up to standby power mode.
When the server module is in standby power mode, the green Power/OK LED on
the front panel blinks, indicating that the service processor (SP) is working and the
system is ready to be fully powered on to main power mode. See
FIGURE 2-1
for the
LED location.
Note – See your chassis documentation for information about powering on the
chassis.
2. Use a non-conducting pointed object, such as a stylus to press and release the
recessed Power button on the server front panel. See
FIGURE 2-1
for the Power
button location.
When main power is applied to the full server, the green Power/OK LED next to
the Power button lights and remains lit.
FIGURE 2-1
shows the location of the power button.
You can also use the SP to turn on main power.
■
From the the ILOM or ELOM CLI, enter
start /SYS
.
■
From the ILOM or ELOM web interface, use the Remote Power Control screen.
See the corresponding SP documentation for details.