Sturtevant Richmont TCVe2, Руководство пользователя

Страница: 16 / 36

TCV e2 User Manual 16 of 36 P/N 857414 Rev A
07/01/2020
ToolsNet
This chapter describes the support for the ToolsNet Open Protocol in the TCV e2. Implementation of the
protocol is according to ToolsNet Open Protocol version 3.5. The TCV e2 reports System Type as 29 and
System Name as “ TCV e2 ”. The setup menu for ToolsNet is located under the IP Info Group
programming menu.
Int 1 Enabled
Default: Disabled
This setting determines if the qualifier will attempt to establish ToolsNet connections for the specified
interface. Unlike the other network protocols supported by the qualifier, ToolsNet requires the
controller to establish connections. Since the qualifier will repeatedly make network requests to attempt
to establish network connections to the ToolsNet server, you should only enable ToolsNet if you have a
server set up in the network and only for the interfaces that are in use.
Int 2 Enabled
Default: Disabled
This setting determines if the qualifier will attempt to establish ToolsNet connections for the specified
interface. Unlike the other network protocols supported by the qualifier, ToolsNet requires the
controller to establish connections. Since the qualifier will repeatedly make network requests to attempt
to establish network connections to the ToolsNet server, you should only enable ToolsNet if you have a
server set up in the network and only for the interfaces that are in use.
PIM Address
Default: 192.168.001.066
This setting controls the IP address the qualifier will use to establish a ToolsNet connection.
PIM Port
Default: 06575
Range: 0 to 65535
This setting controls the port the qualifier will use to establish a ToolsNet connection at the PIM server
address.
PIM Retry Interval
Default: 60
Range: 0 to 3600 seconds
This setting controls how long the qualifier will wait after a failed attempt to establish a ToolsNet
connection before it tries again.
Result Timeout
Default: 5
Range: 0 to 60 seconds
This setting controls how long the qualifier will wait for a response from the ToolsNet server when
sending a tightening or keep alive packet. If no response is received within the specified result timeout,
the qualifier will try again, up to the specified number of retries. If no response is received after all
retries, the ToolsNet connection is considered broken and will have to be reestablished.