Copyright © 2006 – STM Norway AS
Publication no. 101557, Rev. T, November 3
th
, 2006
Page 58
14.3 DVB-S2 Configuration
For operators that already have the SatLink 1910 IDU, a DVB-S2 upgrade path exists using the SatLink
100 extension module that plugs into the rear of the SatLink 1910. Units can be field-upgraded – there is
no need to return units to STM for reconfiguration. The only requirement is that power is turned off when
inserting the new extension card
Figure 5: The SatLink 100 DVB-S2 Extension Module
To enable the SatLink 100 card on a SatLink 1910 IDU, only one command is required on the CLI
interface.
dvb rx phy -satlink100
Type the
device show
command to verify that the card has been detected. See the text in
bold.
# device show
System Information
--------------------------------
Name : not set
Location : not set
Contact : not set
System Up time : 2 days, 23:57:20
System time : not set, TDT not received
HW
--------------------------------
Model : SatLink 1910
HW ID : 103798
Main board ID : 103719 R6.5
Plugin-card HW
--------------------------------
Model : SatLink 100
HW ID : 107261
Revision : 1.1
Serial Number : 0206010006
MAC addresses
--------------------------------
Ethernet (LAN) : 00:60:c0:2f:ba:83
Satellite (DVB) : 00:60:c0:2f:ba:83