Copyright © 2006 – STM Norway AS
Publication no. 101557, Rev. T, November 3
th
, 2006
Page 97
Appendix K. The boot SW
The STM SatLink Terminal has two SW applications installed:
1)
Boot
2)
DVB-RCS Application
The Boot SW is stored outside the file system and can be compared with the BIOS and MS-DOS on a PC.
It is used to have access to file system and the LAN when there is no application loaded on the STM
SatLink Terminal.
The Boot SW is always loaded after powering on the STM SatLink Terminal. But normally the user need
not care about the boot SW since the DVB-RCS application is loaded by default.
The boot-loader can only be accessed via RS-232 as described in Appendix B. After power on, an output
similar to this is displayed on the HyperTerminal:
STM SatLink Boot-loader
- SW ID 101225, Revision 8.0.0.0
File system initialised
Press return to enter boot-loader
In order to logon and use the boot SW, press return (the software will wait 10 seconds before
automatically loading the DVB-RCS application):
1.
When
Login
is displayed type the user name
install
2.
When
Password
is displayed type
dvbrcs
9
In the boot-loader a minimal CLI is available, supporting the file system commands and access to the
LAN. Type
?
(question mark) to display the available CLI commands.
9
dvbrcs is the factory default password and might have been changed by the user
