Still FM-X EW Series, Оригинальное руководство пользователя

Страница: 145 / 360

Operation
4
Lifting
1
2
Removal
– Extend the reach carriage fully.
– Select a pallet corresponding to the fork arm
size.
– Position the pallet to the left or right of the
fork carriage.
– Raise the fork carriage until the lower edges
of the fork arms are approx. 3 cm higher
than the height of the pallet.
– Switch off the truck.
– Undo the locking screw (2) on the right or
left.
– Pull the locking lever (1) upwards and push
the fork arms outwards onto the pallet.
Installation
– Position the fork arms on a pallet to the left
or right of the fork carriage.
– Pull the locking lever (1) upwards.
– Push the fork arms onto the fork carriage
from the outside towards the centre.
– Move the fork arms into the desired position.
Ensure that the locking lever snaps into
place.
– Fit and tighten the locking screw (2).
DANGER
There is a risk to life caused by a falling load or fork!
– Tighten the locking screw after every fork
replacement.
– It is not permitted to drive or transport loads
without the locking screw.
50988078001 EN - 10/2018 133