Still FM-X EW Series, Оригинальное руководство пользователя

Страница: 129 / 360

Operation
4
Driving
2
1
Checking the reach measurement
system for foreign objects
DANGER
Risk of injury due to movement of the reach carriage
during the test
Switch the truck off before the test. Disconnect the
battery male connector.
The reach measurement system consists of
the reach travel sensor (1) and a reference bar
(2). Foreign objects between the sensor and
the reference bar may interfere with the reach
travel measurement. The driver can perform a
visual inspection.
The reach travel measurement is located
on the left load wheel support of the reach
carriage.
– To gain access to the measurement sys-
tem, fully extend the truck battery with the
reach carriage. To do this, observe the
information in the chapter entitled "Oper-
ation/Handling the battery/Actuating the
battery lock".
– Switch off the truck. Disconnect the battery
male connector.
– If necessary, remove any foreign objects
between the sensor and the reference bar.
– Connect the battery male connector. Switch
the truck on.
– Fully retract the reach carriage with the
battery again until the battery lock engages
audibly.
– Then re-reference the reach measurement
system (see above).
50988078001 EN - 10/2018 117