STARPLUS STSe Key System, Руководство по установке

Страница: 84 / 94

4-16 Remote System Monitor
Chapter 4 - Maintenance and Troubleshooting
STARPLUS STSe - Installation Manual August 2005
Event Trace Mode
The T command enables and disables the STSe System Trace mode. While the trace mode is
enabled events for the trace desired displays on the monitor, printer or PC connected to the
STSe system. To view the current status of the trace mode type [ t ] and press <Return> at the
mon> prompt, the following screen displays:
Figure 4-6: Trace Mode Status
1. To enable an Event Trace, type t<space> (space bar).
2. Indicate type of trace desired [d], where d is determined as follows:
3. Enter the specific board, CO line or Station number of the trace desired, or type all when
all boards, CO lines or Stations events are desired.
001-028 = CO Line port
100-149 = Station location
All = All Boards, CO lines or Stations
B Board event trace (traces events associated with PCB)
M Miscellaneous State event trace
P Pulse Coded Modulation (PCM) traces events associated with voice
communications
C CO Line (LCOB) States (traces events associated with CO Line activity)
S Station (STA) States (traces events associated with Station activity)
E Error Messages (traces error messages)
Q Queue (QUE) Events (traces queuing events: DTMF receiver, UCD, LCR, etc.)
D D = Device Command (traces commands to peripheral devices)
mon>t
Cmd Messages Y/N
--- -------- ---
B - BOARD EVT -> N
C - COL States -> N
D - Dev PP Cmd -> N
E - Error Msg -> N
H - H/W States -> N
I - CTI PP Msg -> Y
K - LCD PP Cmd -> N
L - LED PP Cmd -> N
M - MSC States -> N
P - PCM -> N
Q - Que Evt -> Y Trace ALL
S - Stn States -> N
mon>