STARPLUS STSe Key System, Руководство по установке

Страница: 83 / 94

Remote System Monitor 4-15
Chapter 4 - Maintenance and Troubleshooting
STARPLUS STSe - Installation Manual August 2005
Monitor Password
The Monitor feature, like Maintenance, is entered via a six-character alphanumeric string. The
password prompt is accessed by pressing the <Enter> key at the PC connected to the
RS232-1 port (COM1) of the BKSU or connected to the modem. After the prompt displays, type
the password, then press <Enter>. Proper entry of the password results in the mon> prompt.
»
The Maintenance password is: etrace
Help Menu
A convenient Help Menu is provided by typing [ ? ] , then pressing <Enter>. The following screen
displays:
Figure 4-5: Help Menu
Dump Memory Data
Three options allow the memory structure to be dumped for viewing. The options are entered
as follows:
c [c] – Dump CO Line memory structure
s [s] – Dump Station memory structure
d [a][a] – Dump a memory address structure
The data obtained from these commands is in hexadecimal format and is used primarily for
manufacturer-level support.
The Remote Monitor feature is intended for use only under the guidance and
instruction by authorized personnel from Vodavi Technical Support. Care and
caution must be observed when using this feature as permanent damage to the
software structure can occur.
Press the <ESC> key to abort the Data Dump and return to the mon> prompt.
mon>?
command list:
? - help menu
a board - board-cmd slot,cmd,data1,data2
b rate - set baud rate
c [c] - dump co data
d [a][a] - dump memory
e [s] - dump prot sta data
f - flush minor alarm log
g [s] - dump local sta data
h - hdlc status report
k - key-cmd sta,cmd,data1...data17
l - display minor alarm log
m add - modify memory
n - display stack trace
p - Send Sta Event (Sta Event Data1 Data2)
q - Send Sta Event (Sta Event Data1 Data2) & exit monitor
s [s] - dump sta data
t [d] - set trace key
x - exit monitor