Star Headlight & Lantern LCS850MG, Инструкция по установке и эксплуатации

Страница: 9 / 64

-6-
Installation: Dip Switch Settings
Control Head Dip Switch Settings
(cont’d)
Audio Pursuit, Visual Pursuit, Progressive SS, and TD Compatibility
AUDIO PURSUIT ENABLE (DIP switch 5) and VISUAL PURSUIT ENABLE (DIP switch 6)
Normally slide switch position

 

activates “Pursuit Mode”:
a. The lights connected to all 3 slide switch positions will activate.
b. The siren will activate in Wail mode.
c. Your compatible traffic director (if connected to this unit) will activate in the
Warn mode.
To disable automatic activation of the siren (AUDIO PURSUIT) in position
   
, flip DIP
switch 5 up.
To disable automatic activation of the traffic director (VISUAL PURSUIT) in position
   
,
flip DIP switch 6 up.
V
IS
U
A
L
P
T
E
N
A
B
L
E
A
U
D
IO
P
T
E
N
A
B
L
E
TD Auto-Activates in
Pursuit or Programmable
Traffic Director Does NOT
Auto-Activate in Pursuit
Siren Auto-Activates in
Pursuit or Programmable
Siren Does NOT
Auto-Activate in Pursuit
5 6
P
R
O
G
R
E
S
S
IV
E
E
N
A
B
L
E
Progressive SS
Non-Progressive SS
or Programmable SS
D
IS
C
R
E
T
E
T
D
Use 3 or 4 Output Signal for
TD w/Internal Controller
(Logic Controlled)
Use Built-In 8-Output
Siren TD Controller
8
PROGRESSIVE ENABLE (Progressive Slide Switch Enable)
Normally the slide switch is “progressive” , meaning that each
position will add another function while keeping the previous
one(s) on. Position
1
1 1
1
activates the first function. Position
2
2 2
2
activates the functions connected to both
1 1 1 1
and
2 2 2 2
. Position
   
will activate all of the functions connected to
1 1 1 1
,
2 2 2 2
, and
3 3 3 3
.
To disable this feature so that each slide switch position is
independent from the others
, flip DIP switch 7 up.
DISCRETE TD (Traffic Director Compatibility: 8-Output or 4-Output Logic)
TD Mode DIP switch (switch #3) must be ON (see page 5)!!
The default settings of this unit allow for operation
of our standard 8-head traffic directors
(i.e. TD77,
TD92, TD93) through an internal controller within the
LCS850MG using 10 outputs from the 12-terminal
connector.
If the traffic director you will be using has a built-in
controller and only needs three or four “signal” wires to
operate, then flip DIP switch 8 up.
With this switch up, the default setting will be for
operation of our DL15-30W. To program the LCS850MG
to operate other traffic directors, please refer to page 32
of the Detailed Programming section.