Star Headlight & Lantern LCS850MG, Инструкция по установке и эксплуатации

Страница: 13 / 64

-10-
Installation
Traffic Director Settings
This section only applies to those applications in which the TD CYCLE on the control
head will be used to operate a traffic director (arrowstick). If you are NOT using this
button to control a traffic director, you can skip to page 14, after ensuring that DIP switch 3
(TD MODE), on the back of the Control Head, is in the
OFF position (see page 5) .
Traffic Director Settings
PB13 is normally used as a TD Cycle
button to control an approved traffic
director (arrowstick) by scrolling through
the four main traffic directing patterns:
WARN, LEFT, RIGHT, and CENTER OUT.
Pressing this button will activate your
traffic director and will illuminate the
TD
Indicator LEDs on the bottom of the
control head in the same pattern that the
traffic director is displaying.
By default, the LCS850MG is compatible with any of our ground-side switched 8-head traffic
director (e.g. TD77, TD92, TD93, etc.) and will use its own internal controller to drive the
“dummy” heads in the traffic director. The
Standard 8-Output Mode is also compatible with 6-
head traffic directors (e.g. lightbars with only 6 TD heads) or 8-head TDs in which only 6
heads are used in the traffic directing pattern (and the heads on each end are flashed back
and forth).
If your traffic director has a built-in TD controller and only requires “Signal” or “Logic” inputs
(e.g. the DL15-30W), there are also three (3) additional TD compatibility modes. Skip to page
13 if you will be using a controller that is already built in to your traffic director.
Standard 8-Output Mode (default setting)
If you will be using the internal
controller of the LCS850MG to
operate your traffic director,
please verify that DIP switches
3 and 8 on the back of the
control head are set properly.
(See pages 5 & 6)
Connect the 10 wires from your traffic director harness to the 12
-terminal connector that plugs into
the back of the LCS850MG-AMP
box. The last two terminals of
the connector will be empty.
If you are only
controlling six
heads, do not use
terminals 1 and 8.
8-Output Discrete Wiring
Traffic Director Harness
7
(
V
io
le
t)
C
a
b
le
S
h
ie
ld
(
G
ro
u
n
d
)
R
E
D
W
IR
E
(
M
A
X
2
0
A
M
P
S
)
8
(
G
ra
y
)
4
(
Y
e
ll
o
w
)
6
(
B
L
U
E
)
3
(
O
ra
n
g
e
)
5
(
G
R
E
E
N
)
2
(
R
e
d
)
1
(
B
ro
w
n
)
This section only applies to those Traffic Directors that normally require a
separate control box and use inputs for each individual head. Skip to page 13 if
you will be using a controller that is already built in to your traffic director.
D
IS
C
R
E
T
E
T
D
Use 3 or 4 Output Signal for
TD w/Internal Controller
(Logic Controlled)
Use Built-In 8-Output
Siren TD Controller
8
T
D
M
O
D
E
Using
Traffic Director
Not Using
Traffic Director
3