Star Headlight & Lantern LCS850MG, Инструкция по установке и эксплуатации

Страница: 58 / 64

-51-
Cloning
The LCS850MG has been designed to allow for the settings of one unit to be “cloned” or
copied to another unit, thus reducing the time that it takes to program multiple units. This
feature is extremely useful when setting up fleets of vehicles that will all be using the same
(or similar) options.
After setting the
options on the
first unit, follow
the procedure
below to copy
them onto a
second unit (or
multiple units).
1. After programming the first LCS850MG-CH (control head), make sure it is connected to
the amp (this will be the Master Amp), turn it on by applying power to the one of the
Power wires and the Remote Enable wire (terminal #4 of the 12-way connector). The
Ground wire should also be connected. Ensure slide switch is in the OFF position.
2. Place the unit into Programming Mode by flipping the programming DIP switch up (see
page 8 for details about the Programming DIP switch).
3. Move the slide switch to
position
3 3 3 3
.
4. Press the RADIO button.
5. Press PB1 . The unit will
then begin to beep non
stop.
Please Note: Do not leave the unit beeping for more than a few
seconds as it will eventually corrupt the memory.
6. Flip the programming DIP switch down (out of Programming Mode). This will “save” the
settings from the current control head onto the Master Amp.
7. Disconnect the “master” control head.
8. Attach the new control head to the Master Amp that you would like to “clone” from the
“master” control head.
9. Turn the new unit on by applying power to the one of the Power wires and the Remote
Enable wire (the Ground wire should also be connected), and ensure the slide switch is
in the OFF position.
10. Place the new unit into Programming Mode by flipping the programming DIP switch up.
11. Move the slide switch to position
3 3 3 3
.
12. Press the RADIO button.
13. Press the MAN button. The unit will then begin to beep non stop.
14. Flip the programming DIP switch down (out of Programming Mode). The original
“master” control head settings are now saved onto the new control head.
15. To clone additional control heads, repeat steps 8-14. The Master Amp will remember
the saved settings even if turned off.
3
3 3
3
RADIO PB1
Write Settings from Master Control Head to Amp
3 3 3 3
RADIO MAN
Write Settings from Master Amp to Control Head
3 3 3 3
RADIO HORN
CPU Start
S
lid
e
S
w
itc
h
A
u
d
io
M
o
d
e
A
c
tiv
a
tio
n
B
u
tto
n
Function
Cloning