Star Headlight & Lantern LCS850MG, Инструкция по установке и эксплуатации

Страница: 35 / 64

-28-
Installation: Detailed Programming
Tone Sweep Disable in HF for Slide Switch
3
3 3
3
High-Low (Two-Tone) Override of Phaser Tone

Review the Sweep Disable section on page 8.

SWEEP DISABLE DIP switch must be set for ‘Auto Tone
Sweep in HF’.
If, when in HF mode, you only want the siren to automatically “sweep”
through all of the other tones when the siren is activated by the AUX
input/HRT, and you DO NOT want the tones to sweep when the siren
is activated by Slide Switch
3 3 3 3
, then change this setting:
If PB14 is Red : (Default setting) SS
3 3 3 3
WILL activate Tone Sweep when the siren is in HF
mode and the SWEEP DIP switch is up.
If PB14 is Green : SS
3 3 3 3
WILL NOT activate Tone Sweep when the siren is in HF mode and
the SWEEP DIP switch is up. Only the AUX input will activate the tone
sweep.
By default, the Phaser tone is enabled on this siren. This tone can be replaced with a High/
Low siren (also known as Two Tone or the European sound), if desired. Some municipalities
may have regulations regarding the use of the Phaser tone and you may wish to replace it
with the High/Low tone.
If you would like to use the High/Low tone instead of the Phaser tone, change this setting.
If PB1 is Green : (Default setting) Phaser tone functions normally.
If PB1 is Red : Phaser tone is replaced by the High/Low tone.
Once you have programmed all necessary options, you must flip
the Programming Mode DIP switch down to save the changes.
Once you have programmed all necessary options, you must flip
the Programming Mode DIP switch down to save the changes.
High-Low (Two-Tone) Override of Phaser Tone
Tone Sweep Disable in HF for Slide Switch
3
3 3
3
Programming Mode DIP Switch: Up
Slide Switch: OFF
Audio Mode Buttons (HF/WAIL/YELP/PHSR/RADIO): All OFF/Green
And modify this button: PB14
Programming Mode DIP Switch: Up
Slide Switch:
2 2 2 2
Audio Mode Buttons (HF/WAIL/YELP/PHSR/RADIO): All OFF/Green
And modify this button: PB1
13
Auto Tone
Sweep in HF
Manual Tone
Cycle in HF
S
W
E
E
P
D
IS
A
B
L
E
All of the options on pages 17
All of the options on pages 17 All of the options on pages 17
All of the options on pages 17----34 can optionally be programmed using free software and a
34 can optionally be programmed using free software and a 34 can optionally be programmed using free software and a
34 can optionally be programmed using free software and a
USB to serial cable (P/N SUSB USB to serial cable (P/N SUSB USB to serial cable (P/N SUSB USB to serial cable (P/N SUSB----850MG) available upon request from StarSignal at 585 850MG) available upon request from StarSignal at 585 850MG) available upon request from StarSignal at 585 850MG) available upon request from StarSignal at 585----226 226 226 226----9787. 9787. 9787. 9787.