Midilift SL
Installation Guide
October 2016
Version 9
53
18.2 Upper Level Door
Fitting is the same as for lifts with an upper level gate (see 18.1) with the following
exceptions:
1) Upright infill angles will stop 105mm below the top of the corner upright.
2) The top guide infill panel should be flush with the top of the upright infill angle.
3) The guide top infill plates & 75mm upright infill top pieces are not required.
Note:
The structural ceiling must be fitted before fitting the top cover panels. This also
applies to the upright infill panels opposite the guides.
10mm Bottom of lowest panel to pit floor.
Upright Infill Angles
(fit first)
Guide Infill Panels
(fit second)
Corner Upright Cap
(fit last)
Self Drill Screw
Plastic Cap
Dome Hd Rivet
View on Arrow 'A'
A
105mm Top of corner upright to top
of guide & corner upright infill panels
