Midilift SL
Installation Guide
October 2016
Safety Edge Installation Issues
Safety Edge Bar Bouncing
If the Safety Edge Bar ‘Bounces’ and activates the Mircoswitches on start in the up direction,
increase the tension in the springs by turning the Nylon Adjustment Pin anti
secure in place with the M4 Locking Nut bene
Ensure that the springs do not become Coil Bound (see note below).
Safety Edge Bar Limited Movement
If the Safety Edge Bar cannot move the required distance when depressed (to activate the
switches and is Coil Bound) increase the travel of the safet
Adjustment Pin clockwise to the required position, and secure in place with the M4 Locking
Nut beneath.
Safety Edge Bar fails to reach Switch
If the Safety Edge Bar moves the required distance but fails to activate the microswit
not reaching; loosen the Switch Bkt Fixings to allow movement in the Mircoswitch brackets
and adjust position to achieve the required gap (1.5mm±0.5) to the Safety Edge Bar.
Please ensure multiple test runs are carried out, including stop/starts
adjustments have been made to fully test the safety edge adjustment.
Fitting Platform Deck
Lay the platform deck onto the platform and secure with the M4 CSK HD fixings. Adjust the
Panel Support Angles so that the front face is level wit
Panel Support Angle.
Position to be level with carriage legs.
Version 9
Safety Edge Installation Issues
If the Safety Edge Bar ‘Bounces’ and activates the Mircoswitches on start in the up direction,
increase the tension in the springs by turning the Nylon Adjustment Pin anti
secure in place with the M4 Locking Nut beneath.
Ensure that the springs do not become Coil Bound (see note below).
Safety Edge Bar Limited Movement
If the Safety Edge Bar cannot move the required distance when depressed (to activate the
switches and is Coil Bound) increase the travel of the safety bar by turning the Nylon
Adjustment Pin clockwise to the required position, and secure in place with the M4 Locking
Safety Edge Bar fails to reach Switch
If the Safety Edge Bar moves the required distance but fails to activate the microswit
not reaching; loosen the Switch Bkt Fixings to allow movement in the Mircoswitch brackets
and adjust position to achieve the required gap (1.5mm±0.5) to the Safety Edge Bar.
Please ensure multiple test runs are carried out, including stop/starts
adjustments have been made to fully test the safety edge adjustment.
Lay the platform deck onto the platform and secure with the M4 CSK HD fixings. Adjust the
Panel Support Angles so that the front face is level with the carriage legs.
Platform fixings
Panel Support Angle.
Position to be level with carriage legs.
27
If the Safety Edge Bar ‘Bounces’ and activates the Mircoswitches on start in the up direction,
increase the tension in the springs by turning the Nylon Adjustment Pin anti-clockwise, and
If the Safety Edge Bar cannot move the required distance when depressed (to activate the
y bar by turning the Nylon
Adjustment Pin clockwise to the required position, and secure in place with the M4 Locking
If the Safety Edge Bar moves the required distance but fails to activate the microswitches, by
not reaching; loosen the Switch Bkt Fixings to allow movement in the Mircoswitch brackets
and adjust position to achieve the required gap (1.5mm±0.5) to the Safety Edge Bar.
Please ensure multiple test runs are carried out, including stop/starts mid travel, when
adjustments have been made to fully test the safety edge adjustment.
Lay the platform deck onto the platform and secure with the M4 CSK HD fixings. Adjust the
h the carriage legs.
Platform fixings
