47
vertical) motion unit. However, the value cannot be less than
the minimum vertical movement amount, and it must be in
even units of the minimum vertical movement amount.
In standard mode, the vertical motion unit (y) is used.
In page mode, this command functions as follows,
depending on the starting position of the printable area:
Whe
①
n the starting position is set to the upper left or lower
right of the printable area using
ESC T
, the vertical motion
unit (y) is used.
②
When the starting position is set to the upper right or lower
left of the printable area using
ESC T
, the horizontal motion
unit ( x) is used.
The maximum paper feed amount is 1016 mm (40 inches).
Even if a paper feed amount of more than 1016 mm (40
inches) is set, the printer feeds the paper only 1016 mm (40
inches).
[Default] Line spacing equivalent to approximately 4.23mm
(1/6 inches).
[Reference]
ESC 2
,
GS P
ESC = n
[Name] Set peripheral device
[Format] ASCII ESC = n
Hex 1B 3D n
Decimal 27 61 n
[Range] 1
n
3
Содержание SP-T8
