SPRT SP-T8, Руководство пользователя

Страница: 33 / 125

33
[Notes]
 The right -side character spacing for double-width mode is
twice the normal value. When characters are enlarged, the
right-side character spacing is n times normal value.
 This command does not affect the setting of
Chinese
characters.
 This command sets values independently in each mode
(standard and page modes).
 The horizontal and vertical motion unit are speci fied by GS
P . Changing the horizontal or vertical motion unit does not
affect the current right-side spacing.
 The GS P command can change the horizontal (and
vertical) motion unit. However, the value cannot be less than
the minimum horizontal movement amount, and it must be in
even units of the minimum horizontal movement amount.
 In standard mode, the horizontal motion unit is used.
 In page mode, the horizontal or vertical motion unit differs
in page mode, depending on starting position of the printable
area as follows:
When the starting position is set to the upper left or lower
①
right of the printable area using ESC T , the horizontal motion
unit ( x) is used.
When the starting position is set to the upper right or lower
②
left of the printable area using ESC T , the vertical motion unit
( y) is used.
 The maximum right -side spacing is 255/180 inches. Any