SpectraLink Link 150, Инструкция по установке и эксплуатации

Страница: 58 / 89

SpectraLink Link 150 Installation and Operation
12/28/98 50
Station Features for Wireless Telephone
Station features on Page 1 of the station form can be assigned or copied as determined in
the pre-installation procedures. The following settings must be set for the wireless
telephone:
•
Type: 8410D
•
Name: the wireless telephone user's name, if there is a permanent user assigned.
•
Auto Answer: None (this is the default, and forces calls to ring the wireless telephone)
Programming Buttons
The technician can assign Call Appearances, Line (trunk) Appearances, and features to
buttons to fit user needs.
If the wireless telephone will be used in conjunction with a wired station, administer the
wireless telephone as a Bridged Appearance of the wired station.
•
Assign buttons 1-3 as bridged appearances (brdg-appr) of the wired station. This will
allow the first three appearances on the wired station to correspond to the first three
appearances on the wireless telephone.
•
Assign buttons 4-5 as call appearances (call-appr). This must be done because
DEFINITY requires at least two call appearances of the extension on each station.
•
To make the wireless telephone ring when the wired station rings, change Bridged
Call Alerting to Yes on the wired station.
If the wireless telephone is not a bridged appearance of a wired station, assign buttons 1-3
as call appearances (call-appr).
5. Duplicate Programming on Wireless Telephones
After the model wireless telephone or telephones have been completely programmed, use
the duplicate station command to copy the programming to all “like” wireless
telephones. Change the extension of the bridged appearance on each set as it is copied.
The installer can now test the wireless telephones.